Technical Data

INTELLIGENT FEATURES
Main Computer Autonomous and manual cleaning modes, controlling
all aspects of cleaning including water flow,
chemistry, head pressure and repeatable high level
of cleaning performance
Safety Monitoring
Computer
Dual redundant computers monitor all aspects of
the machine pertaining to safe operation and immediately
halt motion and motor upon detection of any
unsafe conditions
Drive Subsystem Precise control of the drive motors to ensure correct
motion and position of the machine
Controls Manual and Robotic; Icon-based touchscreen with on-screen help in 9 languages; emergency stop button to halt machine and cleaning**
Front Touch Shield Full width, Grey ABS, touch-sensitive shield provides
immediate braking
Rear Touch Shield Full width, Grey ABS, touch-sensitive shield provides
immediate braking
Security User-specific password protection to prevent unauthorized
use combined with screen locking system
Safety Sensors Two level safety touch shield 360° around the machine; four dual redundant infrared floor sensors; 190° scanning laser and 360° ultrasonic sonar for obstacle detection
Navigation Sensors Triple range ultrasonic sonar for near, mid and far for tracking the environment; scanning laser to navigate spaces 190+ feet (60 m) wide; angular rate sensor and optical encoders for precision machine location
Navigation System Simple, no programming usage for basic cleaning patterns and sophisticated map programming for large complex cleaning of entire sites
INTELLIGENT SYSTEM
IntelliFlow Water consumption management allowing you a
reduction up to 76%
IntelliDose On-board chemical dosing system allowing you
up to 70% chemical savings
Intelli-Trak In direct contact with your cleaning operators
IntelliTrail Ensure optimization of your TASKI fleet
IntelliPad Allowing you to have a clean and shiny floor in
one pass
BRUSHES AND SQUEEGEE
Pads Two counter-rotating drivers and pads available. Robot also works with TASKI standard brushes
Brush Drive Motors Two 24 V VDC; 0,65 HP; 150 RPM; Direct drive
Brush Head Brushes/pads are changeable without removing
head from machine
Scrubbing Width 28 inch (70 cm)
Scrubbing Pressure 0.29 N/cm2 or 42,5Kg/93,69 lbs
Squeegee 35 inch (90 cm) self-tracking parabolic squeegee with EZ-lok system for simple maintenance. Plastic non-marking end rollers and quick change, reversible rubber blades
Turning Circle 1.4 m/ 4.6 feet
DRIVE SYSTEM
Battery Option Sealed gel cell deep cycle, 180 AH, 24 VDC output
Battery Capacity 180 Ah (Standard set up)
Performance Run time up to 4 hours
Theoretical Performance 1260 m2
Practical Performance (low congestion) 1050 m2
Speed 1.8 km/h
Optional Exchange Kit Run time can be doubled with battery exchange kit
that requires no heavy lifting
Charger Unit 20 AMP, 24 VDC output, available in 115 VAC input with automatic shutoff
CONSTRUCTION
Machine Length 53 inch / 135 cm
Machine Width 35 inch / 90 cm
Machine Height 50 inch / 128 cm
Tank Capacity Fresh water: 90L
Waste water: 90L
Machine Weight Empty/incl Batt/ Ready to use 252 kg / 376 kg / 471 kg or 555 lbs / 829 lbs / 1038 lbs
APPROVALS
IP Protection Class IPX3
Electrical Protection Class III
Regulatory Aspects CE; CB (end of 2017); DIN 18032
ENVIRONMENT
Humidity 20% to 75% relative humidity
Noise (LpA) <70 dB(A)
Uncertainty (KpA) 2.5 dB(A)

* Cleaning rate may vary, depending on environment